Author Archives: intelform.webmaster

IgentForm & IgentDraw – improvements

New point input modes during contour definition:  – Project orthogonally entered points on the coordinate system axes The option allows entering any contours with perpendicular sides – Create the entered point orthogonally based on the last and two points clicked The option allows, f.ex.closing the contour with two perpendicular lines Point input modes can be scrolled back […]

Read More

IgentForm – new possibilities

Display of hatched sections of already defined columns in 2D view. This is especially helpful when adding columns based on a DXF background Significantly increased functionality when adding walls based on a DXF background – possibility of automatic selection of collinear lines creating walls and recognition of openings – the option of narrowing the selection […]

Read More

IgentDraw – shaft reinforcement

Possibility of automatic generation of reinforcement drawings for shafts in foundation slabs. After defining the contour of the shaft hole and specifying parameters (shaft height, wall width, spacing and bar diameters), the program automatically generates all necessary reinforcement regionsand sets the appropriate parameters. When reinforcement is turned on, drawings are created automatically. A video demonstrating […]

Read More

IgentDraw – new option

Extended possibility of defining bar division locations In addition to the coordinate of the division, it is possible to enter the range in the perpendicular direction. No second coordinate means that the zone is valid to the end of the region in perpendicular direction. This option allows to optimize the number of regions

Read More